Good morning Crafty friends!
Card
size: 4 5/8” X 6 7/8”
Cut white cardstock 9 1/8” X 6 7/8” then
score at 3 3/16” and 7 ¾” (There should be approximately 4 5/8” in the
middle. Be sure when closed edges meet).
Cut decorative panels for the 3 inside sections and for the 2 outer sections
that make up the front of card. Before
gluing any paper on, glue half the magnet to the top 1 3/8” section in the
center, add tape over the top so that magnet does not move while glue is wet. Put the other half of magnet onto glued
magnet from the other side, add a drop of glue then close flap down, this will
mark where the other half of magnet will go.
Glue the half magnet down where glue spot is and add a piece of tape.
(The tape will not affect the magnets pull).
Glue decorative paper over the two magnet halves, one on outside short
flap and one on inside middle section toward the top. Now finish gluing the rest of the decorative
paper panels on to matching card sections.
Cut both decorative dies from lavender
cardstock and from silver cardstock.
Glue matching die cuts together, lavender to silver off-setting slightly.
Glue larger bottom die cuts to the bottom
section of card front, close the top flap and glue the top decorative die so
that it just overlaps bottom die slightly on the sides (make sure to put glue
ONLY where the top flap is, you don’t want to glue the card shut!
Stamp and emboss using VersaMark and silver
embossing powder, the stars and snowflakes X 2, Heralding angel, angel with
bird, and Noel. Die cut all pieces.
On the inside center panel, glue the angel
with bird, Noel and some of the small stars and snowflakes, be careful not to
cover where you know the magnet is.
On the top flap, glue the large star and
some smaller stars to the 2 sides, glue the 2 large snowflakes and a star to
the bottom 2 corners.
Die cut another Heralding angel from
lavender as a back for the embossed angel (it will show when open, this will
also strengthen the angel. Now pop up
the angel to top flap only so that card can open.
No comments:
Post a Comment
Thanks for stopping by! Your comments are so appreciated!!